DHCPv6 SNTP Option: Simple Network Time Protocol (SNTP) Configuration Option for DHCPv6

Network Working Group                                  V. Kalusivalingam
Request for Comments: 4075         Cisco Systems (India) Private Limited
Category: Standards Track                                       May 2005


  Simple Network Time Protocol (SNTP) Configuration Option for DHCPv6

Status of This Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2005).

Abstract

   This document describes a new DHCPv6 option for passing a list of
   Simple Network Time Protocol (SNTP) server addresses to a client.

1.  Introduction

   This document describes a new option, called the SNTP [3] servers
   option, for passing information about SNTP servers in DHCPv6 [1].

2.  Requirements

   The keywords MUST, MUST NOT, REQUIRED, SHALL, SHALL NOT, SHOULD,
   SHOULD NOT, RECOMMENDED, MAY, and OPTIONAL, when they appear in this
   document, are to be interpreted as described in RFC 2119 [2].

3.  Terminology

   This document uses terminology specific to IPv6 and DHCPv6 as defined
   in the "Terminology" section of the DHCPv6 specification [1].

4.  Simple Network Time Protocol (SNTP) Servers Option

   The Simple Network Time Protocol servers option provides a list of
   one or more IPv6 addresses of SNTP [3] servers available to the
   client for synchronization.  The clients use these SNTP servers to
   synchronize their system time to that of the standard time servers.
   Clients MUST treat the list of SNTP servers as an ordered list.  The
   server MAY list the SNTP servers in decreasing order of preference.

   The option defined in this document can only be used to configure
   information about SNTP servers that can be reached using IPv6.  The
   DHCP option to configure information about IPv4 SNTP servers can be
   found in RFC 2132 [4].  Mechanisms for configuring IPv4/IPv6 dual-
   stack applications are being considered, but are not specified in
   this document.

   The format of the Simple Network Time Protocol servers option is as
   shown below:

       0                   1                   2                   3
       0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |      OPTION_SNTP_SERVERS       |        option-len            |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                                                               |
      |                  SNTP server (IPv6 address)                   |
      |                                                               |
      |                                                               |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                                                               |
      |                  SNTP server (IPv6 address)                   |
      |                                                               |
      |                                                               |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
      |                              ...                              |
      +-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+


      option-code: OPTION_SNTP_SERVERS (31)

      option-len:  Length of the 'SNTP server' fields, in octets;
                   it must be a multiple of 16

      SNTP server: IPv6 address of SNTP server

5.  Appearance of This Option

   The SNTP servers option MUST NOT appear in messages other than the
   following: Solicit, Advertise, Request, Renew, Rebind, Information-
   Request, and Reply.  If this option appears in messages other than
   those specified above, the receiver SHOULD ignore it.

   The option number for this option MAY appear in the Option Request
   Option [1] in the following messages:  Solicit, Request, Renew,
   Rebind, Information-Request, and Reconfigure.  If this option number
   appears in the Option Request Option in messages other than those
   specified above, the receiver SHOULD ignore it.

6.  Security Considerations

   The SNTP servers option may be used by an intruder DHCPv6 server to
   cause DHCPv6 clients to contact a rogue SNTP server, resulting in
   invalid synchronization of time in the client, finally leading to
   time-critical applications running inaccurately in the client
   machine.  Time accuracy can be crucial to some security algorithms.
   For example, expired certificates may gain a new life, making the
   applications running on the client machine less secure.  The
   inaccuracy can even cause clients to set their time incorrectly,
   making them vulnerable to replay attacks in protocols that use time
   stamps to detect replays.

   To avoid attacks through these options, the DHCPv6 client SHOULD use
   authenticated DHCPv6 (see the "Authentication of DHCP messages"
   section in the DHCPv6 specification [1]).

7.  IANA Considerations

   The IANA has assigned an option code to the following from the
   option-code space defined in the "DHCPv6 Options" section of the
   DHCPv6 specification [1].

   Option Name            Value    Described in
   OPTION_SNTP_SERVERS    31       Section 4.

8.  Acknowledgements

   Thanks to the DHC Working Group for their time and input on the
   specification.  In particular, thanks to (in alphabetical order)
   Bernie Volz, Jim Bound, Margaret Wasserman, Pekka Savola, Ralph
   Droms, Robert Elz, and Thomas Narten for their thorough review.

9.  Normative References

   [1]  Droms, R., Bound, J., Volz, B., Lemon, T., Perkins, C., and M.
        Carney, "Dynamic Host Configuration Protocol for IPv6 (DHCPv6)",
        RFC 3315, July 2003.

   [2]  Bradner, S., "Key words for use in RFCs to Indicate Requirement
        Levels", BCP 14, RFC 2119, March 1997.

10.  Informative References

   [3]  Mills, D., "Simple Network Time Protocol (SNTP) Version 4 for
        IPv4, IPv6 and OSI", RFC 2030, October 1996.

   [4]  Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor
        Extensions", RFC 2132, March 1997.

Author's Address

   Vijayabhaskar A. Kalusivalingam
   Cisco Systems (India) Private Limited,
   No: 9, Brunton Road,
   Bangalore - 560025
   India

   Phone: +91-80-51036615
   EMail: vibhaska@cisco.com

Full Copyright Statement

   Copyright (C) The Internet Society (2005).

   This document is subject to the rights, licenses and restrictions
   contained in BCP 78, and except as set forth therein, the authors
   retain all their rights.

   This document and the information contained herein are provided on an
   "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
   OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET
   ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED,
   INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE
   INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
   WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Intellectual Property

   The IETF takes no position regarding the validity or scope of any
   Intellectual Property Rights or other rights that might be claimed to
   pertain to the implementation or use of the technology described in
   this document or the extent to which any license under such rights
   might or might not be available; nor does it represent that it has
   made any independent effort to identify any such rights.  Information
   on the procedures with respect to rights in RFC documents can be
   found in BCP 78 and BCP 79.

   Copies of IPR disclosures made to the IETF Secretariat and any
   assurances of licenses to be made available, or the result of an
   attempt made to obtain a general license or permission for the use of
   such proprietary rights by implementers or users of this
   specification can be obtained from the IETF on-line IPR repository at
   http://www.ietf.org/ipr.

   The IETF invites any interested party to bring to its attention any
   copyrights, patents or patent applications, or other proprietary
   rights that may cover technology that may be required to implement
   this standard.  Please address the information to the IETF at ietf-
   ipr@ietf.org.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.